The temperature should be at least 65 degrees Fahrenheit (18.33 Celsius) to apply. DECAL APPLICATION INSTRUCTIONS 1. Clean the area where the decals will be applied with a soft cloth dampened with alcohol. This will remove anything that will prevent the decal from sticking. After wiping the area with alcohol it is best to wipe the surface with a cloth dampened with clean water and let dry. 2. Carefully peel the tape and decal away from the wax paper backing. Hold the decal in position and stick the top or one side holding the other side up away from the surface. Rub the entire area beginning at the top or side that is on the surface and rub firmly from one side to the other using your fingertips or the sharp edge of a credit card. The decals have a pressure sensitive adhesive the harder you rub the harder it sticks. 3. Remove the application tape by pulling gently in a downward position. If a part of the decal starts to come up away from the surface rub it back down while the tape is still on, then proceed to remove the tape. LARGE DECALS APPLICATION For large decals, we recommend the wet application or professional installation. Wet Application For wet application (good for large decals) peel wax paper backing all the way off. In a spray bottle put 1 or 2 drops of dish soap, shake well. Spray the application surface. Lay decal and surface, use a squeegee or credit card to squeegee out water trapped underneath the decal, start from the middle and work your way out while holding the decal in place. Decal will have to sit for about 5-15 minutes, rub decal again, start from the inside outward and let sit for an additional 5-15 minutes. Repeat until decal sticks to the surface. Then remove top clear transfer tape. WARNING: If there are any air bubbles in the decal DO NOT use a needle or razor blade to poke holes in the air bubbles. Most air bubbles will flatten to the surface in a few days. Do not use a squeegee or credit card directly on the decal surface, this will scratch the decal. Enjoy your decal. |